Tuesday, March 27, 2012

Welcome to Tutorial Tuesday! I've been excited for this weeks segment- I found the most adorable tutorial at FellowFellow.com last week. Enjoy!

Sweet DIY Votives

Posted on September 27th by ffadmin | 
Here’s what you’ll need:
1. Measure the height and circumference of your jar, and cut strips of fabric to roughly fit (approx. 1cm wide – doesn’t have to be perfect).
2. In your small cup, pour in some glue and dilute it with a bit of water (about 1:2), mix well. It should be the consistency of slightly thicker water.. yes, I know I’m being vague but it shouldn’t make much difference to the end result.
3. Submerge your first strip of fabric in the glue. Once soaked, lightly run your thumb and forefinger down the strip to get rid of any excess glue.
4. Place the strip into your jar (pattern side facing the jar) and position it. Use your paintbrush to push any air bubbles out from between the fabric and the jar.
5. Repeat with the rest of your fabric. Allow to dry overnight before using.
Note:
- It would be best to use battery operated tea lights instead of real candles
- I find that it’s ok to have fabric going above the top of your jar because it can be easily cut off after it’s dried.
- I don’t mind the look of the overlapping lines of fabric once the candle is lit, but if you do try not to overlap the strips in the gluing process.

** I’m just going to add this little disclaimer… please be careful! Even though I’ve used real candles in my jars, it would be better to use battery operated tea-lights. If you do decide to go with real candles, make sure your jar is big enough that the candle has plenty of room around it (the bigger the better), with no chance of the flame touching the fabric. Make sure the glue is dried overnight before using the votives, and keep an eye on them – if you see any signs of them starting to burn, stop using them immediately! **"


No comments:

Post a Comment